Embed Size (px)
Citation preview
Tronical Components Gm
bH | Heselstücken 18 | 22453 Hamburg Germ
any | Phone: +49 (40) 28 46 45 7 - 81 | ww
w.tronical-com
ponents.com | store.tronical-com
ponents.com | support@
tronical-components.com
There are different templates available for this Headstock – check which one fits your guitar following the guide below:
1. Printer Settings: - Size Setting: 100% - Page Adaption: None - Page Scaling: None
2. Place a ruler onto the printed templates to check correct printout size
3. Cut-out the templates 4. Place the templates on the back of your guitar headstock. Check if the holes of the template are congruent to the holes of your guitar. When they are congruent you identified the template that fits your guitar. Enter this type during the order process.
TRONICALTUNE PLUSTemplate Types
TOP
TOP
TOP
TOP
TOP
TOP
TOP
Type A Type B Type B1 Type D Type E Type E1 Type E2
TOP Type F
TOP Type G
TOP Type H
TOP Type H1
TOP Type I
TOP
Type J TOP
Type L TOP
Type M TOP
Type N TOP
Type O TOP
Type P TOP
Type R TOP
Type T TOP
Type T1
TOP
TOP
TOP
Type U Type Y Type Z
Tronical Components Gm
bH | Heselstücken 18 | 22453 Hamburg Germ
any | Phone: +49 (40) 28 46 45 7 - 81 | ww
w.tronical-com
ponents.com | store.tronical-com
ponents.com | support@
tronical-components.com
Scale: Inch Scale: cm
PLACE RULER HERE
8,6
68,
35
54,
1
112,09
46
38,
1
31,
75
41,28 41,28
Werkstoff (Endzustand) / material (fi.co.)
Tronical GmbH Heselstuecken 18www.Tronical.com D-22453 Hamburg
Material <nicht festgelegt>Allg. Toleranzen / gen. tolerances
ISO 2768 f
Proj. Methode /proj. method ISO 5456-2
Aenderungsindex / Aenderungsbeschreibungstate of revision / revision text CAD ZGS Auftrags-Nr.
order no.Bearb. / auth.Datum / date
Pruef. / checkDatum / date
Norm / stand.Datum / date
SolidWorks
Benennung / title
Massstab / scale1:1
System / systemSolidWorks
CAD X
ZGS Masse / mass (g)15
Oberfl.sch. / surf.prot.Farbe / colorDekor / decorationOberfl.ang. / surf.textureOberflaeche / surface (mm²)
Bearb. / auth.Pruef. / checkNorm / stand.
Freig. / rel.
Datum / date Name / name
11880
Behandlung 3D:
PDMW Version3D: PDMW Version2D: PDMW Projekt: PDMW Author3D: PDMW Author2D: PDMW Status3D: PDMW Status2D:
x x x xxxx xxxx xxxx xxxx
Version Nr. / version no.
Schutzvermerk DIN 34 beachten! / Refer to protection notice DIN 34!
Format / size Blatt / sheet Sach-Nr. / basic number
A4 1 of 1 W1
Type W1
TOP
Type W1
max. 16.2mm
